In this project of Thales Germany with the participation of Rehm Thermal Systems, TU Dresden, Fraunhofer IZM, Koh Young Europe and Omron the focus was laid on Land Grid Arrays (LGA). During the seminar about “Soldering” at the SMTconnect Technology Days the process-specific possibilities for reducing the void content in the solder joints of these components to a level of < 10% and some important influencing factors will be presented. For the investigations, modules were available that were equipped with LGA32 and LGA35 (Fig. 1), among others.
The internal structure of this LGA and the complex two-sided assembly made X-ray analysis particularly difficult with regard to the precise evaluation of the void content in the solder joints (Fig. 2). Within the scope of the project, various X-ray methods (2D-X-Ray, laminography, X-ray CT) were used for comparative purposes in order to obtain evaluable data. In addition to the variations of the PCB design and the material parameters, the final vacuum pressure has been the overall influencing factor on the minimization of the void content (Fig. 3).
With decreasing pressure in the environment of the molten solder joints, their void content decreases significantly. In general, good LGA solder joints could be produced. The solder wetting of both the LGA connections and the PCB pads was uncritical, as the metallographic investigations prove. The solder gap characteristics essentially correspond to theoretical expectations and the variance is more influenced by the design of the PCB pads than by the voids. The microsections produced reveal the details of the topography of both joining partners, the printed circuit board and the LGA.
Figure 4 shows a section of an LGA32 solder joint in darkfield contrast on which the dimensions of the respective solder resist masks and the gap remaining between them are dimensioned. Only these remaining 13 µm allow the LGA to float in (self-centering) during soldering. Tolerances in the general manufacturing process can further shrink this gap so that both solder resist masks lie on top of each other, making it impossible for the LGA to self-centering.
"With extensive investigations and tests a solution could be found for the increasing demands on solder joints."
- Circuit board